The boat they made on GardenFork.tv, which I was using as the basis for my design, was made of a single sheet of plywood. It was about 24” wide with sides about 12” high. Though Eric from GardenFork.tv is a trim guy, his narrow boat road very low in the water when he launched it as a solo passenger. As I wanted to be able to take my kids (and even other adults) in the boat with me, I decided I would need two (2) sheets of plywood.With this as a plan, I headed straight to Lowes once we were settled in at Lake George (and I was back from the trip to Fine Woodworking Live I made immediately after arriving).
Yep, thats what a boat looks like before its put in the water.
Since the ¼” luan I used on the mock boat was awfully damn thin, and the plywood bottom would need to support me, I opted to use ?” CDX plywood. Though it was bowed and coarsely textured as most CDX is, I felt it provided me the best mix of strength, weight and cost. For the battens, I chose to switch to 2”x2”, so the tips of the screws wouldn’t poke through the ¾” thickness of the 1”x used in the mock boat. I also bought some 2”x4”, metal saw horse brackets and a small drop cloth so I could work at a comfortable height and keep the mess in check.
Ready for ripping!
In the parking lot, I had to rip down the 4’x8’ sheets of plywood before they would fit inside my truck. This being upstate New York, there was no problem woodworking in the parking lot.More (Ply)Wood Boat Posts.
0 komentar:
Posting Komentar