After I spokeshaved the first blank into a dowel, I regrouped and took a full size sketch I had made based on Kenneth’s photos and made copies. Then I took the copies and the remaining four (4) blanks down to my Dad’s shop. I glued on the sketch copies and fired up the band saw (mine doesn’t quite run right now). When I was done, I was left with four (4) square pieces of wood that had the rough in and out nature of the wands.
Two (2) wands fresh off the bandsaw, and one post rasping.
I took the post-bandsaw blanks home and started to make them round. I began with my spokeshave on the thin, long business end of the wands. This quickly knocked down the corners and the round shape began to emerge.
The wonderful Shinto Rasp.
Next I began rasping. The rough shaping was continued with my Shinto rasp set up in course mode. By holding the rasp at about a 75° relative to the length of the wand and working my choice up and down the length while tipping the rasp back and forth over the wand I was able to get all three (3) sections of each wand relatively round. They weren’t perfect, but as they are hand made by eye, they were just the right combination of uniformity and uniqueness.
A wand, post rasping, and the wonderful Auriou rasp I used to fine tune the work of the Shinto.
I cleaned up the initial rasping with the Shinto set up in fine mode and for the final shaping I moved to my Auriou rasp. I used it to clean up the inside corners and edges as well as create the recessed area in the middle of the handle portion of each wand.
The four (4) wands, ready to be freed from their bases.
At this point the wands were shaped, but still attached to square stock at the butt of their handles. The square stock had been left to allow them to be clamped in my bench vises.
Time to cut.
I cut the square stock off using my Veritas Carcass Saw. I then went back to the Auriou rasp and made the final shaping to the butt end of the handles.
The four wands, ready for finish (not for cutting).
Once you finally get there, do you often find the scary part of a project actually wasnt so bad?
0 komentar:
Posting Komentar